Control and Servo Technology (5 ECTS)
Code: TX00BU96-3005
General information
- Enrollment
- 02.12.2019 - 07.01.2020
- Registration for the implementation has ended.
- Timing
- 16.03.2020 - 31.07.2020
- Implementation has ended.
- Number of ECTS credits allocated
- 5 ECTS
- Mode of delivery
- On-campus
- Unit
- (2019-2024) School of Automotive and Mechanical Engineering
- Campus
- Leiritie 1
- Teaching languages
- Finnish
- Seats
- 0 - 50
- Degree programmes
- Mechanical Engineering
Objective
On completion of the course, the student
• recognises when feedback control is required and is able to understand the significance and difference between actuators
• is able to dimension actuators based on both static and dynamic loads
• is able to use mathematical methods to tune and select the components of various systems.
Content
• Regulators and their function
• Comparison of open and closed control loops
• Using simulation for control development
• Frequency analysis
• Dynamic properties of actuators
• Commissioning a closed loop system
Evaluation scale
0-5
Assessment criteria, satisfactory (1)
The student
• knows the difference between open and closed loop control
• recognises the difference in the dimensioning of static and dynamic systems
• is able to apply simulation to analyse a simple system.
Assessment criteria, good (3)
The student
• knows the difference between open and closed loop control
• is able to dimension a dynamic system and recognises the significance of dynamics when choosing components
• is able to apply simulation to analyse a simple system.
Assessment criteria, excellent (5)
The student
• knows the difference between open and closed loop control and is able to choose a suitable control system for an application
• is able to dimension a dynamic system and can choose the components taking the requirements of the dynamic system into account
• is able to apply simulation to analyse a system
• is able to commission a control system.
Assessment criteria, approved/failed
The student
• knows the difference between open and closed loop control
• recognises the difference in the dimensioning of static and dynamic systems
• is able to apply simulation to analyse a simple system.
Qualifications
Basics of Automation and Measurement Technology