CAD ja tietomallinnus (5 cr)
Code: TX00EB53-3002
General information
Enrollment
04.05.2020 - 30.08.2020
Timing
28.08.2020 - 11.12.2020
Number of ECTS credits allocated
5 op
Mode of delivery
Contact teaching
Unit
Kiinteistö- ja rakennusala
Campus
Myllypurontie 1
Teaching languages
- Finnish
Degree programmes
- Talotekniikan tutkinto-ohjelma
Teachers
- Sunil Suwal
- Aamos Lemström
Groups
-
TXF19S2_KIINTKiinteistöjohtamisen opintopolku
-
TXF20S2Talotekniikan tutkinto-ohjelma monimuoto
Objective
CAD
The student is able to draw HVAC drawings of a simple building using CAD design software.
BIM
Student can
• explain the fundamentals of building information model/modelling/management (BIM)
• define key approaches, uses and advantages of BIM during the whole life-cycle
• recall essential contents, summarize and give examples of BIM terminologies, definitions and standards.
• describe and utilize BIM methods and tools in construction processes.
Content
CAD (4 ects): HVAC drawings. The basics of CAD design. Making simple HVAC designs for a single family house using a CAD application.
BIM (1 ects)
• Introduction to BIM
• BIM guidelines, policies and regulations
• IFC basics and information exchange
• BIM tools, technologies and processes
• BIM utilization in project life cycle
Evaluation scale
0-5
Assessment criteria, satisfactory (1)
The student is able to prepare the HVAC plans of a simple building holistically with the help and instructions and to make them work as a single entity to serve the building using a CAD design program. The student understands the basics of using data modeling.
Assessment criteria, good (3)
In addition to the above, the student is able to apply a CAD design program and independently draw up plans
Assessment criteria, excellent (5)
In addition to the above, the student is able to apply a CAD design program and independently draw up plans at an almost error-free level.
Assessment criteria, approved/failed
The student is able to prepare the HVAC plans of a simple building holistically with the help and instructions and to make them work as a single entity to serve the building using a CAD design program. The student understands the basics of using data modeling.