Design of Safe and Reliable Systems (3 op)
Toteutuksen tunnus: TX00DB89-3005
Toteutuksen perustiedot
Ilmoittautumisaika
03.05.2021 - 31.07.2021
Ajoitus
02.08.2021 - 06.08.2021
Opintopistemäärä
3 op
Virtuaaliosuus
3 op
Toteutustapa
Etäopetus
Yksikkö
ICT ja tuotantotalous
Toimipiste
Karaportti 2
Opetuskielet
- Englanti
Paikat
0 - 24
Koulutus
- Degree Programme in Information Technology
- Tieto- ja viestintätekniikan tutkinto-ohjelma
Opettaja
- Norbert Jung
- Marcel Hasler
Ryhmät
-
ICTSUMMERICT Summer School
Tavoitteet
After completion of this course the student will be able to perform an application specific risk analysis, has knowledge of the fundamental defect mechanisms and load-bearing limits of hardware components, the typical error mechanisms in software components and can design a fail-safe technical system for a given purpose, which ensures the required minimum amount of functionality for a safe operation in case of a defect by suitable measures. Methodological competencies: Interdisciplinary thinking, acting and communication.
Sisältö
1. Introduction
2. Learning from accidents
3. Risk analysis and risk reduction methods
4. Robust design of hardware and software
5. Methods for failure tolerance
6. Safety architectures
7. Robot competition
Aika ja paikka
2.8.2021 - 6.8.2021 (morning 09:00-13:00)
Oppimateriaalit
- Electronic Safety Systems, Josef Börcsök
- IEC EN 61508 (Functional Safety, Safety Related Systems)
Opetusmenetelmät
- lectures
- group work
- presentations
Tenttien ajankohdat ja uusintamahdollisuudet
Exam on the last day of the intensive week
Kansainvälisyys
Course teachers are Prof. Dr. Norbert Jung and Marcel Hasler (M.Sc.) from University of Applied Sciences, Bonn-Rhein-Sieg, Germany.
Opiskelijan ajankäyttö ja kuormitus
Lectures 5x4h
Home exercises 10h
Project 30h
Self study 20h
Total 80h = 3ECTS
Arviointiasteikko
0-5
Arviointikriteeri, hyväksytty/hylätty
The course assessment is based on
- active attendance
- continuous assessment of lab exercises
- individual contribution to project
- short exam at the end of the intensive week
Arviointimenetelmät ja arvioinnin perusteet
The course assessment is based on
- active attendance
- continuous assessment of exercises
- individual contribution to project
- short exam at the end of the intensive week
It is highly recommended that students attend all sessions.
Esitietovaatimukset
1. C-Programming fundamentals
2. (Digital) electronic circuits
3. Mechatronic basics